如果您对该产品感兴趣的话,可以
产品名称:
日本SMC超薄型气动滑台，原装SMC气动滑台
产品型号:
-
产品展商:
SMC
简单介绍
日本SMC超薄型气动滑台，原装SMC气动滑台
1. Our pressure sensor controllers are CE marked;
however, they are not equipped with surge protection
日本SMC超薄型气动滑台，原装SMC气动滑台的详细介绍
日本SMC超薄型气动滑台，原装SMC气动滑台
Helium leakage test is conducted on the welding parts. Use a
ferrule by Swagelok Company (Swagelok㈢ fittings) as the TSJ
fittings and packing, ground, etc. by Swagelok Company
(VCR㈢ fittings) as the URJ fittings. If a ferrule, packing or
ground by other manufacturers are to be used, conduct helium
leakage test before using those products.
. Swagelok㈢ and VCR㈢ are trademarks of Swagelok Company.
4. About intrusion of water or drainage
Although the pressure sensor of this switch employs a stainless
steel diaphragm that would not be damaged by water,
there are cases in which the inertial force of sudden irruption
at the time of vacuum release after adsorption confirmation
causes water, or drainage contained in the air, to strike the
pressure sensor and damage it.
In the case that water or drainage occurs, an intermediate orifice
can be set up, or an adapter with external deflection (ZS-
31-X175, X186) can be mounted to the fitting part of the main
3. Applicable crimping terminal dimensions
An M3 terminal screw is used.
If employing a crimping terminal, please use the part shown
1. Incorrect wiring can damage the switch and cause
malfunction or erroneous switch output.
Connections should be done while the power is
2. Do not attempt to insert or pull out the pressure
sensor or its connector when the power is on.
Switch output may malfunction.
3. Wire separately from power lines and high voltage
lines, avoiding wiring in the same conduit with
these lines. Malfunctions may occur due to noise
from these other lines.
4. If a commercial switching regulator is used, make
1. Connection and removal of sensor connector
?Hold the lever and connector body with two fingers and insert
the connector straight into the pin until it is locked with a
?If the product is mounted on a panel, the 揑P65?
enclosure rating is applicable only to the front
parts. Do not use in an environment where oil
splashing or spraying are anticipated.
Operating Environment
日本SMC超薄型气动滑台，原装SMC气动滑台
