如果您对该产品感兴趣的话,可以
产品名称:
小金井低速双活塞杆式气缸,日本KOGANEI气缸
产品型号:
-
产品展商:
KOGANEI
简单介绍
小金井低速双活塞杆式气缸,日本KOGANEI气缸
Use in combination with speed controllers, as shown in the
diagram below, is effective for low speed control as well as
jump start prevention
小金井低速双活塞杆式气缸,日本KOGANEI气缸的详细介绍
小金井低速双活塞杆式气缸,日本KOGANEI气缸
The average speed is obtained by dividing the stroke by the time
Suitable for low speed transfer of fragile workpieces.
Cylinder’s outer dimensions are the same as
the standard product.
3. Air used for the cylinder should be clean air that contains no
deteriorated compressor oil, etc. Install an air filter (filtration
of a minimum 40 μm) near the cylinder or valve to remove
collected liquid or dust. In addition, drain the air filter
periodically.
Collected liquid or dust entering the cylinder may cause
improper operation.
Enable stable operation from 1mm/s [0.04in./sec.].Note
Smooth operation without stick-slips.
Wide range of cylinders are available:
6 types and 10 bore sizes.
Speed controllers for low speed cylinders
required to travel the stroke. The above average speed values
were obtained by tests undertaken at Koganei. They do not imply
guaranteed values of the product.
The speed value reads positive when the cylinder is extended.
1mm/s = 0.03944in./sec. 1mm = 0.0394in.
Always thoroughly blow off (use compressed air) the tubing
before piping. Entering metal chips, sealing tape, rust, etc.,
generated during piping work could result in air leaks or other
defective operation.Except the items listed below, all outer dimensions,
cylinder specifications, sensor switch specifications,
2. Use air for the media. For the use of any other media, consultus.
