主营产品:阀门、气动元件、仪器仪表、电子元器件
产品[

德国易福门位置传感器,IGT241[产品打印页面]

]资料
如果您对该产品感兴趣的话,可以
产品名称: 德国易福门位置传感器,IGT241
产品型号: IGT241
产品展商: IFM易福门
简单介绍
德国易福门位置传感器,IGT241 金属螺纹 M18 x 1 接插件 增长的感应距离 镀金触点 感应距离 8 mm; [f] 齐平安装

德国易福门位置传感器,IGT241的详细介绍

德国易福门位置传感器,IGT241


金属螺纹 M18 x 1
接插件
增长的感应距离
镀金触点
感应距离 8 mm; [f] 齐平安装
 电气数据
电气设计   DC PNP
工作电压 [V]  10...36 DC
电流损耗 [mA]  < 10
防护等级   II
反相保护   是
 输出
输出功能   常开
电压降 [V]  < 2.5
电流负载 [mA]  100
短路保护   脉冲
过载保护   是
开关频率 [Hz]  400
 监控范围
感应距离 [mm]  8
工作距离 [mm]  0...6.5
 精度/偏差
修正系数   钢(St37) = 1 / 不锈钢约0.7 / 黄铜约0.5 / Al约0.5 / Cu约0.4
迟滞 [Sr的百分比]  1...20
 环境条件
环境温度 [°C]  0...100
外壳防护等级   IP 67
 机械技术数据
安装   齐平安装
外壳材料   外壳: 不锈钢(316S12); 感应面: LCP; 固定螺母: **不锈钢
 显示器/操作件
开关状态显示 LED  黄色(4 x 90°)
 电气连接
接口   M12接插件; 镀金触点

德国易福门位置传感器,IGT241

Active Zone / Active face Area over the sensing face in which the sensor reacts to the approach
of the target.
Output function Normally open: Object within the active zone – output switched.
Normally closed: Object within the active zone – output blocked.
Programmable: Choice between normally closed or normally open.
Positive switching: Positive output signal (to L–).
Negative switching: Negative output signal (to L+).
Power-on delay time The time the sensor needs to be ready for operation after application
of the operating voltage (in the millisecond range).
Hysteresis The difference between the switch-on and the switch-off point.
Leakage current Current for the internal supply of 2-wire units, also flows through the
load when the output is unswitched.
Current consumption Current for the internal supply of 3-wire DC units.
Switch point drift The shifting of the switch point owing to changes in the ambient
temperature.
Short circuit protection ifm sensors which are protected against excessive current by means
of a pulsed short-circuit protection. The inrush current of incandescent
lamps, electronic relays and low resistance loads may cause this
protection to cut in and turn the switch off!
Operating voltage The voltage range in which the sensor functions safely. A stabilised
and smoothed direct voltage should be used! Take into account
residual ripple!
Switching frequency Damping with standard target (mild steel) at half nominal sensing
range. The damped – undamped ratio is 1 : 2.
产品留言
标题
联系人
联系电话
内容
验证码
点击换一张
注:1.可以使用快捷键Alt+S或Ctrl+Enter发送信息!
2.如有必要,请您留下您的详细联系方式!


上海乾拓贸易有限公司    地址:上海嘉定嘉涌路99弄6号713    邮编:
联系人:单先生    电话:021-69000975   手机号码:18918574312    传真:021-39947181
沪ICP备09006758号-2  
 

沪公网安备 31011402005013号

点击这里给我发消息 点击这里给我发消息 点击这里给我发消息 点击这里给我发消息 点击这里给我发消息 点击这里给我发消息 点击这里给我发消息