如果您对该产品感兴趣的话,可以
产品名称:
VQZ225Y-5M0,SMC3通释放残压的手动阀
产品型号:
VQZ225Y-5M0
产品展商:
SMC
简单介绍
VQZ225Y-5M0,SMC3通释放残压的手动阀
1. Cut the end of the tubing at a right angle and pass it
through the fitting nut. After placing the tubing in
the holder, push it onto the insert bushing until it
VQZ225Y-5M0,SMC3通释放残压的手动阀的详细介绍
VQZ225Y-5M0,SMC3通释放残压的手动阀
inspections, and if leakage is detected correct the problem by
additional tightening. If additional tightening becomes ineffective,
replace the fitting with a new product.
4. Check the following during regular maintenance,
and replace components as necessary.
a) Scratches, gouges, abrasion, corrosion
参阅本小册子揌IGH纯含氟聚合物配件HYPER接头？系列
LQ1，2工作程序说明？（M-E05-1），用于连接油管和特殊
工具。 （可下载从我们的网站。）
拧紧螺母的主体的端面上。作为指南，参见
下图所示的正确的拧紧扭矩。
b) Twisting, flattening or distortion of tubing
c) Hardening, deterioration or softening of tubing
5. Do not repair or patch the replaced tubing or fittings
1. After a long period of non-use, perform inspections
1. Perform maintenance in accordance with the procedures
in the instruction manual.
Improper handling can cause damage.
2. When removing or reinstalling fittings, remove any
remaining chemicals and carefully replace them
with deionized water or air, etc., before beginning
3. Tightening of taper threads for piping
Because the taper threads are made of resin, minute leakage
may gradually occur due to stress relaxation. Perform periodic
before beginning operation.
2. Use sufficient care in the handling of series LQ
clean packaging types when their packaging is
3. For LVN Series, be careful not to apply any excessive
force to the stroke end, which fully opens and
closes, to avoid accidental damage or changes in
As a guide when tightening the tubing with the
knob, maintain a uniform gap (approx. 2 mm) on
both sides of the holder.
• When the tubing is curved, straighten it out before using it.
• The tubing may slip if there is oil or dust, etc., on the holder.
