产品[
ESG-10-SN-HCL-QS，进口FESTO真空吸盘[产品打印页面]
]资料
产品名称:
ESG-10-SN-HCL-QS，进口FESTO真空吸盘
产品型号:
ESG-10-SN-HCL-QS
产品展商:
德国FESTO费斯托
简单介绍
ESG-10-SN-HCL-QS，进口FESTO真空吸盘
工作电压范围[V]18...30 DC
剩余波纹[Vss的]4
电流消耗为每Sub-D多针插头连接
电磁线圈额定电压
MPA1 MPA2
标称上拉电流[mA]80 100
额定电流与电流降低[马]2520
时间，直到电流降低[毫秒]25 50
ESG-10-SN-HCL-QS，进口FESTO真空吸盘的详细介绍
ESG-10-SN-HCL-QS，进口FESTO真空吸盘
结构设计中的电磁驱动活塞滑阀
润滑润滑对于生命，不含PWIS（不含油漆润湿缺陷物质）
的安装方式壁挂式安装
在H型导轨符合EN60715
手动操作器推/车削带定位/覆盖
气歧管连接通过单个底座或连接
进气口1 G¼（M7与单个底座）
Nominal voltage [V] 24 DC
Operating voltage range [V] 18 … 30 DC
Max. intrinsic current consumption at 24 V
(regardless of the switching status of the valves)
per electronics module
VMPA1-FB-EMS-8 or VMPA2-FB-EMS-4
VMPA1-FB-EMG-8 or VMPA2-FB-EMG-4
8 not electrically isolated (max. signal line length 10 m)
25 electrically isolated
Diagnostic message on undervoltage UOFF , load voltage
Protection class to EN 60529 IP65 (f
or all types of signal transmission in assembled state)
Max. current consumption per so
lenoid coil at nominal voltage MPA1 MPA2
Nominal pull current [mA] 45 90
Nominal current with current reduction [mA] 8 18
Time until current reduction [ms] 20 20
Calculation example
Current consumption with two solenoid coils MPA2
switched in parallel and one electronics module
without electrical isolation
Nominal pull current [mA] I
VAL =8 + 2 x 90 = 188
Nominal current with current reduction [mA] I
VAL =8 + 2 x 18 = 44
MPA with multi-pin plug connection
排气口3/5的QS-10（M7与单个底座）
工作口2/4根据连接类型选择
先导气口12/14 M7（M5采用单个底座）
先导排气口82/84 M7（M5采用单个底座）
与排气口释放压力管道式空气：
通过端口82/84（M5采用单个底座）
带有平板式消声器：排至大气
