ODE先导活塞式电磁阀安装注意事项
When the coil is energized, the plunger moves, the gasket is mounted thereon,
so that the guide hole opens and discharges the chamber above the diaphragm:
Unbalanced pressure to open the diaphragm of the main hole.
In this group of solenoid valves must have a minimum value between
the inlet pipe and the outlet pipe to ensure that the
pressure between the normal operation of the solenoid valve.
所以如果这个压差是大于螺线管的值阀门已经设计,
usually with the same 2 closed solenoid valve, with pilot control,
Install the normally open kit at the location of the open kit to open and close the guide hole.
So in this case when the coil is energized, the pilot hole is closed,
The diaphragm is thus positioned at the position of the closed body and the
pilot hole in which the coil is not energized is open, thereby causing the main bore to open.
后者可能不会重新打开当线圈不通电时。
However, the pressure difference between the entrance is too large
And the outlet, as is usually the direct effect of the solenoid valve 2,
resulting in the required force to open the pilot valve,
Two-way normally open solenoid valves with pilot control have inlet and outlet tubing.
With regard to the movement of these solenoid valves the function of the diaphragm,
为了正确操作电磁阀,并避免膜片的快速磨损,建议一次启动阀关闭,
When the coil is not energized, there is pressure below the fluid chamber below the diaphragm
The diaphragm has the pressure only in the outer area of the main hole:
thus the force on the diaphragm forces to push it and close the main orifice.
实际流量不高于Kv(即:流量通过阀,压力损失为1巴)。
因此,如果阀门打开时的入口压力,高于1巴,就是不建议使用具有自由出口的阀本身,
Two-way normally closed solenoid valve with pilot control inlet pipe and outlet pipe.
The main hole in the body, through the unbalanced
pressure between the opening of the diaphragm (or piston) on the upper and lower surfaces:
ODE先导活塞式电磁阀安装注意事项