产品[
原装VIKCERS比例放大板EATON比例放大板特点[产品打印页面]
]资料
如果您对该产品感兴趣的话,可以
产品名称:
原装VIKCERS比例放大板EATON比例放大板特点
产品型号:
-
产品展商:
威格士VICKERS
简单介绍
原装VIKCERS比例放大板EATON比例放大板特点
This procedure may also be applied to
the EEA-PAM-5-C-30 and partially to
the EEA-PAM-5-B-30. Refer to Vickers
catalog GB-C-2007C for more detailed
information on these power amplifiers.
This is an easy-to-use procedure for
anyone with a little understanding of
how proportional valves work.
原装VIKCERS比例放大板EATON比例放大板特点
原装VIKCERS比例放大板EATON比例放大板特点的详细介绍
原装VIKCERS比例放大板EATON比例放大板特点
roportional valve solenoids are current
controlled. This current is usually
regulated by varying the command
voltage into the amplifier. The greater
the current to the solenoid coil, the
greater will be the valve spool
displacement (travel) and oil flow
through the valve. By controlling the rate
of current increase or decrease, the
spool displacement or valve opening
rate will increase or decrease resulting
in acceleration or deceleration control of
the hydraulic actuator and its working
load.
A typical circuit for a single stage
feedback type valve in an open (outer)
loop application is shown in Figure 1. A
24VDC power supply is connected to
pins bdz32 (+) and bdz30 (–). An enable
switch connected between bdz32 and
pin z2a is required. The valve is
connected according to the circuit
diagram. A (+) or (–) 10V at 5mA
reference is provided for command
voltage control. When wired as shown in
the diagram, the control pots should be
2000 ohms or greater. If the pot is to be
connected across the (+) or (–) pins z2
and b2, the minimum pot size should be
上海乾拓贸易有限公司
QQ:2880626089
联系人:李春荣
地址:上海嘉定区嘉涌路99弄6号楼713
原装VIKCERS比例放大板EATON比例放大板特点