ASCO电磁阀线圈/SCG353A061[产品打印页面]

]资料

点击看大图

如果您对该产品感兴趣的话,可以

产品名称: ASCO电磁阀线圈/SCG353A061
产品型号: SCG353A061
产品展商: ASCO
简单介绍
ASCO电磁阀线圈/SCG353A061 动作方式常开式、常闭式、往复式阀体材质铸铁、铸钢、不锈钢选配附件电磁阀、阀位反馈限位开关、定位器、空气过滤减压阀衬里材质衬胶、衬氟

ASCO电磁阀线圈/SCG353A061的详细介绍

ASCO电磁阀线圈/SCG353A061
Protect the device against the direct exposure to the sun.
Avoid arranging the device in the proximity of or in
direct contact with any source of heat and electromagnetic field. Connect the device on supply line
other than those used for motor drives or other devices that may cause some noise on the net.
Fix the device on the wall at minimum 60 cm from the floor.
For all input control signals to the Timer (D1a, D5, D6,...)
流体逐级降压，流体方向不断改变，增加流阻，控制流速，防止空化破坏，阀内允许压差15MPa；
多级节流：大流量时四级节流，小流量时五级节流，减少流体对阀芯表面冲刷磨蚀；
节流面与密封面分开，阀芯和阀芯套表面硬化处理，硬度达到HRC70，关闭严密，寿命长；
阀芯表面开有大缺口，流体含有2~3mm焊渣等固体颗粒，阀芯不会卡死，动作灵活；
use anti-flame wires with a minimum section of 0.25 mm².
Before acting on the device for any operation, check for s
afe conditions. For electrical operations never forget to power off, wait 30 seconds for the
internal capacitor discharge before opening. At the end of the operations close the device to
restore the protection degree before powering on again.
管路接口          焊接式、法兰式
阀门形式          直通、角型、Z型
阀盖形式          标准型、散热型
阀内件形式       迷宫套筒式阀内件、多级节流阀芯结构
阀门材料          20#锻钢或不锈钢
阀芯材料          ASTM 440B或其他不锈钢材料
阀芯套材料       ASTM 440B或其他不锈钢材料
填料                因科镍合金丝增强石墨填料
流量特性          等百分比
泄漏等级          ANSI B16.104 IV级 V级 VI级
驱动方式          可配置电动、气动、液动等执行机构
For the electrical connection of supply voltage and cleaning
electrovalves use anti-flame wires with minimum section of 0,75 mm². For output relay
contacts use anti-flame wires with minimum section of 1,5 mm2.
ATTENTION: with output voltage 230VAC we advice you
to use connectors with RC filter or to insert it on every supply line of any ev.

产品留言

标题

联系人

联系电话

内容

验证码

点击换一张

注：1.可以使用快捷键Alt+S或Ctrl+Enter发送信息!
2.如有必要,请您留下您的详细联系方式!