产品[
SY7120-5DZD-02，乾拓经销SMC先导式减压阀[产品打印页面]
]资料
产品名称:
SY7120-5DZD-02，乾拓经销SMC先导式减压阀
产品型号:
SY7120-5DZD-02
产品展商:
SMC
简单介绍
SY7120-5DZD-02，乾拓经销SMC先导式减压阀
Pressure gauge and port plug replacement
Possible to replace the pressure gauge and port plug the the One-touch fitting replacement.
Pressure gauge assembly
SY7120-5DZD-02，乾拓经销SMC先导式减压阀的详细介绍
SY7120-5DZD-02，乾拓经销SMC先导式减压阀
Note) A standard model is equipped with a backflow
function. A main valve opens when the inlet
pressure is released, and then an outlet
pressure backflows into the inlet side.
Note 1) When adding the regulator block, please
use the correct length of tie-rod that
corresponds to the number of required
stations, or add the extension tie-rod.
Note 2) The part number is for a pair of pieces.
出口施加压力和其中的内部压力
完全耗尽。与压力置换
里面存放的是危险的。
轻轻地用手取下固定夹。强行拉可
导致夹弹出，从而导致危险的替代品。
当卸下直型快换接头
从麋鹿块，取下固定夹，连接管或
插头（ KQP - ？ ）与快换接头，拉
支持了由管（或插头） 。
Before disassembly, be sure to check that no inlet or outlet pressure
is applied and exhaust the internal pressure thoroughly before
Additional parts (Please prepare separately.)
Loosen the 4 round head Phillips screws at the corners of the
end block. (Each 2 locations on both the right and left side)
Remove the tie-rod from the end block and regulator block.
该衬套可能损坏，如果在发布的支持
套管的快换接头的释放。
插入剪辑后GRONDIG更换零件
完全插入。如果插入了充分的素材使用，
它可能会导致夹子被释放，以致
当插入管放入肘型单触
装修，保持接头本体在你的手和插入
管。如果管插入不支持，一个
不合理的力可以在块或应用
快换接头，造成漏气或产品
Note) A tie-rod, which is corresponding to the regulator block stations, or
additional tie-rod for increasing the station will be required.
Insert the tie-rod to the end block on the L side, and temporarily
tighten the round head Phillips screws. (2 screws)
Insert each block to the tie-rod.
Temporarily tighten the round head Phillips screws on the R
Additionally tighten the round head Phillips screws on both
sides of the manifold with the recommended tightening torque.
