产品[
日本SMC嵌入式管接头 ，AS1201F-M5-06[产品打印页面]
]资料
产品名称:
日本SMC嵌入式管接头 ，AS1201F-M5-06
产品型号:
AS1201F-M5-06
产品展商:
SMC
简单介绍
日本SMC嵌入式管接头 ，AS1201F-M5-06
KQ2【新】 φ1/8,φ5/32,φ3/16,
φ1/4,φ5/16,φ3/8,φ1/2 Uni螺纹：1/8,1/4,3/8,1/2
特长 因为采用了密封圈密封方式，螺纹拧入时间缩减为1/3。
适用于Rc, G, NPT, NPTF。
日本SMC嵌入式管接头 ，AS1201F-M5-06的详细介绍
日本SMC嵌入式管接头 ，AS1201F-M5-06
注1) 一般工业用水可使用。使用除此之外的水，应与本公司商谈。
冲击压力应抑制在使用压力以下才能使用。
In the case of N.C. and N.O. types, the port which does not receive
operating pressure is released to atmosphere. When intake
and exhaust directly from the valve is not desired due to
problems with the ambient environment or scattering of dust,
etc., install piping and perform intake and exhaust at a location
Refer to the pamphlet 揌igh-Purity Fluoropolymer Fittings HYPER
FITTING?Series LQ1, 2 Work Procedure I
－5~60℃、水的场合: 0~40℃(未冻结时)
ANSI/ASMEB1.20.1-1983(NPT螺纹)
黄铜件全为无电解镀镍
(M-E05-1) for connecting tubing and special tools. (Downloadable
1. Maintenance should be performed in accordance
with the procedures in the instruction manual.
Incorrect handling can cause damage or malfunction of machinery
2. Before removing equipment or compressed air supply/
exhaust devices, shut off the air and power supplies,
①将表面无伤的管子沿垂直断面切断。
(请使用管钳TK-1、2、3，不要用剪子、剪钳
②用手握住管子，慢慢推入，并确实插到底。
③插到底后，轻轻外拉确认管子拔不出来。
and exhaust compressed air from the system.
Further, when restarting equipment after remounting
or replacement, first confirm safety and then
check the equipment for normal operation.
3. Perform work after removing residual chemicals and
carefully replacing them with DI water or air, etc.
①用拇指和食指捏住释放套的凸缘。
②用余下3个手指和手掌牢固地握住管子。
③然后，用拇指和食指将释放套推入的同时，
用其余3个手指和手掌把管子拔出。
④使用过的管子再使用时，要将咬合处切断
4. Do not disassemble the product. Products which
have been disassembled cannot be guaranteed.
If disassembly is necessary, contact SMC.
5. In order to obtain optimum performance from
valves, perform periodic inspections to confirm that
there are no leaks from valves or fittings, etc.
