DG4V-3-2A-M-U-H7-6X/威格士盖板插装阀[产品打印页面]

]资料

点击看大图

如果您对该产品感兴趣的话,可以

产品名称: DG4V-3-2A-M-U-H7-6X/威格士盖板插装阀
产品型号: -
产品展商: VICKERS
简单介绍
DG4V-3-2A-M-U-H7-6X/威格士盖板插装阀 2 Remove the 9 cap screws and disassemble the motor in the vertical position as shown in figures 1. Note placement of small

DG4V-3-2A-M-U-H7-6X/威格士盖板插装阀的详细介绍

DG4V-3-2A-M-U-H7-6X/威格士盖板插装阀
1 Cleanliness is extremely important when
repairing hydraulic motors. Work in a clean
area. Before disconnecting the hydraulic
motor thoroughly clean the exterior. Remove
motor from application and drain the oil from
the motor before disassembly.
For Assemblies with a Back Pressure Relief Valve
2 Install poppet, shims, spring and plug assembly into end cap
cavity. Torque plug/o-ring to 18-22 Nm [162-198 lb-in]. Plug/o-ring
may have light coat of oil or preservative.
Check all mating surfaces. Replace any parts that have scratches or
burrs that could cause leakage. Clean all metal parts in clean solvent.
Blow dry with air. Do not wipe dry with cloth or paper towel because
lint or other matter can get into the hydraulic system and cause
damage. Do not use grit paper or file or grind these parts.
Note: Lubricate all seals with clean petroleum jelly (Vaseline). A good
service policy is to replace all old seals with new seals.
Refer to parts lists covering your Series VIS 45 Two Speed Hydraulic
Motor when ordering replacement parts.
3 Remove shuttle valve (and relief valve if
applicable) from end cap.
4 Remove two plugs from end cap, end
5 Remove two plugs,spring, and spool from
6 Check all mating surfaces. To reduce the
chance of leakage, replace any parts that have
scratches or burrs. Wash all metal parts in
clean solvent. Blow them dry with pressurized
air. Do not wipe parts dry with paper

产品留言

标题

联系人

联系电话

内容

验证码

点击换一张

注：1.可以使用快捷键Alt+S或Ctrl+Enter发送信息!
2.如有必要,请您留下您的详细联系方式!