日本SMC气动位置传感器[产品打印页面]

]资料

点击看大图

如果您对该产品感兴趣的话,可以

产品名称: 日本SMC气动位置传感器
产品型号: -
产品展商: SMC
简单介绍
日本SMC气动位置传感器 3。在2个位置安装支架联合（ISA-3-A）。注）进行的螺丝临时收紧。 4。确认现有交换机的SUP口的凹槽已密封的连接增设车站。

日本SMC气动位置传感器的详细介绍

日本SMC气动位置传感器
1. Mount the seal conduit on the terminal box. For mounting
procedure, refer to the catalog and instruction manual provided
by the manufacturer of the seal conduit.
2. Thread the cable through the seal conduit and arrange wiring
according to the polarity of the terminal block illustrated above.
3. Fasten the seal conduit with a tightening torque not greater
than 5 N􀀀m. Do not hold the terminal box or the switch.
The detection distance is set with the LED level meter and setting
Keep the setting dial pulled out while in use. If released, it will
return to its original position and become unable to rotate.
1. For accuracy in setting, apply a clearance gauge to the detection
nozzle to replicate the set condition in advance.
2. Confirm that the set pressure is applied. If the setting dial is
fully open, the LED level meter appears as .
3. Pull the setting dial and rotate it in the positive direction. The
Throttle setting for blowing to prevent water and cutting oil from
(Clockwise: Close throttle; Counterclockwise: Open throttle)
∗ The setting is not applicable to valves without throttle.
2. Rotate the throttle clockwise for adjustment so that the
detection nozzle will not suck up water or cutting oil.
3. Power on the valve, then off again.
Confirm that the detection nozzle does not suck up water
Note) Do not rotate the throttle more than 5 turns or it will fall
4. The sensor output comes on when the lights on the LED level
meter turn on as . Complete the setting when this condition
5. Apply the clearance gauge again to confirm that the lights turn
2. Setting the installation needle
The installation needle should be moved by the fingertip.
Set the 2 green installation needles at the maximum and
minimum limits of pressure.
After setting the installation needles, locate the OPEN
arrow at the top right position and insert the claws on the
cover into the grooves on the case (indicated by in the
expanded view of A part). Rotate the cover clockwise until
it stops. Confirm that the cover is firmly secured.

产品留言

标题

联系人

联系电话

内容

验证码

点击换一张

注：1.可以使用快捷键Alt+S或Ctrl+Enter发送信息!
2.如有必要,请您留下您的详细联系方式!