如果您对该产品感兴趣的话,可以
产品名称:
SMC小型空气用压力传感器,日本SMC压力传感器
产品型号:
-
产品展商:
SMC
简单介绍
SMC小型空气用压力传感器,日本SMC压力传感器
hen 揂on?is set in the auto-identification mode or when the turned back on in that condition. However, this function in
SMC小型空气用压力传感器,日本SMC压力传感器的详细介绍
SMC小型空气用压力传感器,日本SMC压力传感器
前面板: IP65(使用盘装式) ,其他: IP40
工作温度:0 〜50 ℃,储存: -10至60°C (不结冰,结露)
工作/存储: 35〜85 % RH(无冷凝)
10至500 Hz时取为1.5毫米振幅或98 M/S2加速度较小,在X,Y , Z方向各2小时。每个(断电)
980 M/S2在X, Y,Z方向各3次(断电)
± 0.5% F.S.或更低(基于25 °C )
电源/输出连接: 8P连接器,传感器连接: E- CON连接器
外壳: PBT ;显示:透明尼龙;返回橡胶盖: CR
约。 60克(不包括电源/输出电缆)
耐油重型乙烯电缆, 8芯, ø4.8 ,2米,导线截面积:0.15平方毫米绝缘外径为0.9mm
H Copy function (Series PSE200 only)
Information that can be copied includes the following: Pressure
set values, Range settings, Display units, Output modes,
?When CH1 is copied to CH2, CH3, and CH4, information of OUT1
?When CH2, CH3, or CH4 is copied to CH1, information of OUT1 in
CH2, CH3, or CH4 will be copied only to OUT1 in CH1.
Note) When the copy function is used, the regulating pressure value
of the copied channel may change ? digit.
I Auto-identification function (Series PSE200 only)
This function automatically identifies the pressure range of the pressure
sensor that is connected to the multi-channel pressure sensor
controller, thus eliminating the need of having to reset the range
again after replacing the sensor. This function will be activated either
PSE53). When other pressure sensors are used, this function will
not work. When using other types of pressure sensors, first set the
auto-identification mode to 揂oF? and then proceed to setting the
range. Turning the power back on while in the 揂on?setting can