如果您对该产品感兴趣的话,可以
产品名称:
日本SMC精密减压阀，EVEX1300-04F
产品型号:
-
产品展商:
SMC
简单介绍
日本SMC精密减压阀，EVEX1300-04F
specified properties. Use compressor oil with a
minimal generation of oxidants and install a mist
separator (SMC’s Series AM/AFM). Refer to
日本SMC精密减压阀，EVEX1300-04F的详细介绍
日本SMC精密减压阀，EVEX1300-04F
4 stations or more supply pressure to
the ports 1(P) on both sides of the manifold and exhaust pressure from the port 3(R) on the both
Note 2) When used as a common external pilot, select the internal pilot specification as an applicable valve.
Note 3) Gasket and mounting bolts are equipped.
Note 1) The mass of the base mounting type (D/B/2/4 size) with sub-plate is indicated.
Note 2) All property values indicate maximum values.
Note 3) Use VY2 when the maximum operating pressure is 0.7 MPa or less.
Note 4) Cut off the command signal when the pressure control on the outlet side is not required, such as when the line is temporarily halted, etc.
Refer to Specific Product Precautions on page 736.
Note 5) To lubricate the outlet side of “VY”, use “VY” as an external pilot. Avoid lubrication to the pilot air.
Note 6) The non-lubricated specification is not applicable to these models.
Note 7) The service life is approximately 4000 to 5000 operating hours. (When using AF + AFM)
This may be approximately 3000 hours with ultra-dry air (dew point –40°C or equivalent).
Note 8) Dimensions of VY1 are the same as VY2. (This is the same for manifolds.)
Poor quality air could enhance the spool’s
sliding resistance and may not achieve the
about the durability of a pressure gauge, since it
may be affected by the sudden pressure
changes during operation.
Use 3 core shielded wires measuring 0.5 (mm2)
for the power supply and signal lines according
to the respective number of conductors. When
connecting the shielded braided wire, connect it
to the ground of the signal generator. As a rule,
the electro-pneumatic hybrid regulator should be
installed in a location that is free of noise or is
shielded. If it must be installed in an
environment with poor noise conditions,
eliminate the power supply noise by using a line
filter, Z-wrap, or a spark killler on the 100 V
power supply or signal source line. The length of
the power suply and signal lines must be kept as
日本SMC精密减压阀，EVEX1300-04F
