SMC桨叶式流量开关[产品打印页面]

]资料

点击看大图

如果您对该产品感兴趣的话,可以

产品名称: SMC桨叶式流量开关
产品型号: -
产品展商: SMC
简单介绍
SMC桨叶式流量开关 4. Use at or below the maximum operating pressure and 5. The indicator on the window name plate (Fig. 1) is only a

SMC桨叶式流量开关的详细介绍

SMC桨叶式流量开关
按噪声模拟器方形波噪声 (脉冲宽度1μs)电源端子间±2000V；输入输出线间±600V
10 ～ 55Hz; 振幅0.75mm; X, Y, Z方向各2小时
10 G; X, Y, Z方向各3次
外壳与AC线间: AC1500V、1分钟
外壳与信号接地间: AC500V、1分钟
外壳与AC线间: DC500V, 50M 以上
高精度行程可读出气缸与多输出计数器间超过23m时，
应使用发送接受信号盒(CE1-H0374)。
型号(计数器侧) : DX10M-36S
连接插头型号 : DX30AM-36P
带插头的BCD电缆另行商谈。
1. To adjust flow, remove grommet of the upper cover and rotate
flow adjusting gear using a flat head screwdriver.
Turning clockwise can increase the set flow and turning
counterclock can decrease the set flow.
2. The flow rate setting point is set at the ON flow rate. Therefore,
in the case of the 1a contact, the ON signal is output if fluid
with a higher flow rate than the set flow rate has occurred.
In the case of the 1b contact, the ON signal is output when the
flow rate has decreased from the set flow rate for the amount
that corresponds to the hysteresis.
3. To prevent the chattering that is associated with the fluctuation
of the operating flow rate, set the difference between the set
flow rate and the operating flow rate so that it is as large as
downstream side of the flow switch, and set the level.
Also, when setting levels with a low flow rate at pressures of
0.2 MPa or more, there may be interference between the
indicator needle and the scale plate. In such cases, detach the
indicator needle and scale plate before setting. After setting,
the indicator needle and scale plate can be reattached in

产品留言

标题

联系人

联系电话

内容

验证码

点击换一张

注：1.可以使用快捷键Alt+S或Ctrl+Enter发送信息!
2.如有必要,请您留下您的详细联系方式!