如果您对该产品感兴趣的话,可以
产品名称:
日本SMC压力传感器，SMC数字式压力传感器
产品型号:
-
产品展商:
SMC
简单介绍
日本SMC压力传感器，SMC数字式压力传感器
shows the correct figure, stop turning “P.SET” and release the SET button.
日本SMC压力传感器，SMC数字式压力传感器的详细介绍
日本SMC压力传感器，SMC数字式压力传感器
1. Do not use in locations where there is splashing or spraying of oils and
solvents. Since this unit is open type, if water or oil, etc. make an ingress
etc., the internal circuit may be corroded and result in a mal-function
2. Ground the piping when induction noise is expected to be generated
from piping. When the noise is expected from power wire or high pressure
wire, install the switch away from the noise.
3. Operating fluid is restricted to air and inert gas. Liquid cannot be used.
4. Absolutely never use in an atmosphere where explosive liquid or gases
Unit does not have explosion-proof construction. If used in an atmosphere
of explosive gases, there is a possibility of causing an explosion.
1. Mounting orientation is available either horizontally or vertically.
2. Be sure to hold the main body when handling.
3. Do not drop or strike body. Excessive impact may damage the switch
4. During installation or removal of the sensor, use a wrench on the
Hex.width across flats for R threads. For M5 thread, use it on the rectangular
parts beneath the body. If force is applied to the top of the body or
resin case, damage may be caused to internal parts of the switch.
5. Do not touch the LCD indicator face of the pressure switch during operation.
Static electricity will cause malfunction or damage to the internal parts.
Brown wire Connect to DC source (+) (positive) to enable switch
Black wire Connect (Switch output) to PLC Input Terminal or DC
Blue wire Connect to DC source (–) (negatve) to enable switch
While pressing q SET, turn pressure-setting slotted screw e “P.SET”
(counterclockwise to decrease) and watch the LCD. When the LCD
When line pressure drops to within 10% of established minimum allowable
pressure, the LCD arrow indicator (on the front side) flashes to indicate
the condition. When line pressure drops below the established
minimum pressure the red alarm LED labeled w ALM (on the front
side) comes ON and is continuously illuminated while the low pressure
3. Keep within the maximum operating pressure range. If more pressure
than the maximum allowable operating pressure is applied, LCD displays
“OF” and then it cannot be used. In that case, reset the pressure
and the power source one more time.
日本SMC压力传感器，SMC数字式压力传感器
