产品[
EATON-VICKERS单向阀，DGMX2-5-PP-BW-B-30[产品打印页面]
]资料
产品名称:
EATON-VICKERS单向阀，DGMX2-5-PP-BW-B-30
产品型号:
DGMX2-5-PP-BW-B-30
产品展商:
威格士VICKERS
简单介绍
EATON-VICKERS单向阀，DGMX2-5-PP-BW-B-30
Important: During reassembly, lubricate the new seals with a
petroleum jelly such as Vaseline®. Also lubricate machined
surfaces with clean hydraulic fluid.
EATON-VICKERS单向阀，DGMX2-5-PP-BW-B-30的详细介绍
EATON-VICKERS单向阀，DGMX2-5-PP-BW-B-30
CM11系列 -21 设计号, 多路阀, CM11 系列, -21 号 零件和维修 English M-1729-S
CM2/3 手动, 多路阀, CM2 和 CM3 系列 -20 设计号, CM2 和 CM3 系列 -30 设计号 零件和维修 English M-2400-S
CM2N2--30, 多路阀, CM2 系列 -30 设计号 零件和维修 English M-2403-S
CM3N--30, 多路阀, CM3 系列 -30 设计号 零件和维修 English M-2404-S
CMX100/160 手动控制, CMX 片式多路方向阀-25 设计号, CMX100 和 CMX160
Cleanliness is extremely important when repairing hydraulic
motors. Work in a clean area. Before disconnecting the
hydraulic motor thoroughly clean the exterior. Remove motor
from application and drain the oil from the motor before
2 Remove the 9 cap screws and disassemble the motor in the
vertical position as shown in Figures 1 and 2. Note placement
of small ball checks in Geroler.
3 Remove shuttle valve (and relief valve if applicable) from
4 Check all mating surfaces. To reduce the chance of leakage,
replace any parts that have scratches or burrs. Wash all metal
parts in clean solvent. Blow them dry with pressurized air. Do
not wipe parts dry with paper towels or cloth as lint in a
hydraulic system will cause damage.
Note: Always use new seals when reassembling hydraulic
motors. Refer to parts list 6-152 for seal kit number, replacement
5 Install one poppet, spring and dash pot into shuttle valve
bore from valve plate side of end cap.
6 Install shuttle piston from opposite end of shuttle valve
7 Install one shuttle valve poppet, spring and dash pot onto
8 Install one shuttle valve threaded internal hex plug with
o-ring. Shuttle plug threads may have light coat of oil or
preservative. Torque plug to 37-45 Nm [324-396 lb-in].
9 For a motor with low pressure relief valve, install poppet,
shims, spring and plug. Plug threads may have light coat of oil
or preservative. Torque plug to 23-29 Nm [207-253 lb-in].
