德国IFM电感式传感器，II0006
电 话：O21-3952 9829/3O-8O1O
传 真：O21-6O83 1959
手 机：189 1857 2467
QQ：125 5O9 6653
联 系人：张海情
邮 箱：8010@shqiantuo.com.cn
II-2015-ABOA
电感式传感器
塑料螺蚊 M30 x 1.5
电缆
感应距离 15 mm [nf]
非齐平安装
电气设计 AC/DC
输出功能 常开
工作电压 [V] 20...250 AC/DC
负载电流(持续的) [mA] 350 AC (...50 °C) / 250 AC (...80 °C) / 100 DC
负载电流 (值) [mA] î: 2.2 A (20 ms / 0.5 Hz)
小的负载电流 [mA] 5
短路保护 否
反相保护 否
过载保护 否
电压降 [V] < AC 6.5 / < DC 6
漏电流 [mA] < 2.5 (AC 250 V) / < 1.3 (AC 110 V) / < 0.8 (DC 24 V)
实际感应距离 (Sr) [mm] 15 ± 10 %
工作距离 [mm] 0...12.1
开关点偏移 [Sr的百分比] -10...10
迟滞 [Sr的百分比] 1...15
开关频率 [Hz] 25 AC / 50 DC
修正系数 钢(St37) = 1 / 不锈钢约0.7 / 黄铜约0.4 / Al 约 0.3 / Cu约0.2
环境温度 [°C] -25...80
防护等级 IP 67, II
EMC电磁兼容 EN 60947-5-2
EN 55011: 等级B
MTTF [年] 607
外壳材料 PBT
功能显示
开关状态 LED 黄色
接口 PVC电缆 / 2 m; 2 x 0.5 mm²
重量 [kg] 0.176
注释 建议: 短路后请一定检查产品的安全功能。
配件(同时供货) 2个固定螺母
接线 芯线颜色 BN 棕色
BU 蓝色
德国IFM电感式传感器，II0006
Active Zone / Active face Area over the sensing face in which the sensor reacts to the approach
of the target.
Output function Normally open: Object within the active zone – output switched.
Normally closed: Object within the active zone – output blocked.
Programmable: Choice between normally closed or normally open.
Positive switching: Positive output signal (to L–).
Negative switching: Negative output signal (to L+).
Power-on delay time The time the sensor needs to be ready for operation after application
of the operating voltage (in the millisecond range).
Hysteresis The difference between the switch-on and the switch-off point.
Leakage current Current for the internal supply of 2-wire units, also flows through the
load when the output is unswitched.
Current consumption Current for the internal supply of 3-wire DC units.
Switch point drift The shifting of the switch point owing to changes in the ambient
temperature.
Short circuit protection ifm sensors which are protected against excessive current by means
of a pulsed short-circuit protection. The inrush current of incandescent
lamps, electronic relays and low resistance loads may cause this
protection to cut in and turn the switch off!
Operating voltage The voltage range in which the sensor functions safely. A stabilised
and smoothed direct voltage should be used! Take into account
residual ripple!
Switching frequency Damping with standard target (mild steel) at half nominal sensing
range. The damped – undamped ratio is 1 : 2.
Sensing range
Nominal sensing range sn:
design range of the unit
Real sensing range sr:
individual deviations at room temperature
between 90 % and 110 % of sn
Useful sensing range su:
switch point drift
between 90 % and 110 % of sr
Operating distance sa:
safe switching
between 0 and 81 % of sn
德国IFM电感式传感器，II0006
